lungimsam
Senior Member
- Joined
- Oct 1, 2011
- Messages
- 2,637
- Reaction score
- 1,706
- Guild Total
- 2
First step-
Measure a lot. The black bezel is a touch smaller on its inside hole than the factory hole cut for the bridge hole so using the bezel as a template since means less material will be removed but the pup will still fit.
Oriented it like the neck PUP of the II and flipped it face down get better contact against the face. Drilled the 4 holes and putting screws in to stabilize. Haven’t decided is should draw trace it and then route by freehand or to use the bezel as the routing template. I don’t wanna damage the bezel. Pardon my crooked Bridge pick up as it’s not screwed in because I’m using it’s bezel to trace the neck hole.
Measure a lot. The black bezel is a touch smaller on its inside hole than the factory hole cut for the bridge hole so using the bezel as a template since means less material will be removed but the pup will still fit.
Oriented it like the neck PUP of the II and flipped it face down get better contact against the face. Drilled the 4 holes and putting screws in to stabilize. Haven’t decided is should draw trace it and then route by freehand or to use the bezel as the routing template. I don’t wanna damage the bezel. Pardon my crooked Bridge pick up as it’s not screwed in because I’m using it’s bezel to trace the neck hole.
Attachments
Last edited: