GGJaguar
Reverential Member
What will the nut width be?And, for a little size context...
What will the nut width be?And, for a little size context...
1-3/8"What will the nut width be?
Lookin' great, Chris!
I haven't radiussed the fingerboard yet. That's going to lower the top part.They don't appear centered in the binding, is there a reason for that?
Agree with GADBeautiful work
I had to take a paper sheet and put it on top of my screen to verify - I saw one dot EXTREMELY small part of one dot being higher than others - maybe about 0,1 mm . . . . = 1/250 of an inch - close enough.They don't appear centered in the binding, is there a reason for that?
I'll just have to scrap the whole thing!I had to take a paper sheet and put it on top of my screen to verify - I saw one dot EXTREMELY small part of one dot being hihger than others - maybe about 0,1 mm . . . . = 1/250 of an inch - close enough.
I'll take hand-made over "machine perfect" any day.I'll just have to scrap the whole thing!
(Yes, I'd seen it. Tiny drill bits like to drift, no matter how much you pre-awl.)
... (Sloyd was a Scandinavian system that taught children basic, and some not so basic, hand crafts. Chief among them was learning to use a Sloyd knife for various things. @Nuuska was this a Finnish thing too?) . . .